Kommentar: Einfügen von HTML im Kommentar: Link einfügen: <a href="LINKURL" target="_blank">LINKTITEL</a> Bild einfügen: <img src="BILDURL"> Text formatieren: <b>fetter Text</b> <i>kursiver Text</i> <u>unterstrichener Text</u> Kombinationen sind auch möglich z.B.: <b><i>fetter & kursiver Text</i></b> C Quellcode formatieren: <code>Quellcode</code> BASIC Quellcode formatieren: <basic>Quellcode</basic> (Innerhalb eines Quellcodeabschnitts ist kein html möglich.) Wichtig: Bitte mache Zeilenumbrüche, bevor Du am rechten Rand des Eingabefeldes ankommst ! -> I > > Dear forum members, > > I have developed a prototype of a measuring device with the CC Pro Mega 32 and the CC Pro 32 > > Projectboard using the latest version of the C-Control IDE. That all went very fine. > > The next step was to make a definite device with the 44 pin CC Pro Mega 32. First time I made a PCB > > with a RS232 interface identical to the one on the project board and push buttons for reset and boot. > > Whatever I tried, I could not get the IDE to communicate with the chip. I checked and re-checked the > > connections but could not find anything wrong, but no communication. > > Assuming that I possibly had destroyed the chip, I ordered a new one. At the same time I > > re-designed the PCB such that it doesn't have a RS232 interface or reset and boot buttons any more. > > In stead through a connector cable I connect the RXD, TXD, RESET and PB2 pins together with the Vcc > > and GND of the PCB to the Projectboard, so that that should function as a programming interface. The > > 40 pin CC Pro 32 is then of course not installed on the Projectboard and also the power supply to > > the Projectboard is disconnected. > > But again, also with this set up the IDE cannot find the hardware. I did handle the chip very > > carefully and have thoroughly checked the connections, so I am quite sure that it should work, but > > it doesn't. > > So, I am a bit at my wit's end, and hope that any one of you might have a suggestion where to look for > > a solution. > > Bas > > > > Hallo, > Gibt es überhaupt jemand die ein wirkendes Gerät gebaut hat mit dem C-Control PRO Mega 32 Chip > Conrad Best.-Nr.: 198810 - 62) oder dem Mega 128 Chip? > Wenn ja, möchte Ich sehr gerne wissen wie man dies programmiert hat. > Grusse > Bas > >
